I have a Dlink DFL-80 configured as a PPTP VPN server. Over the
weekend I could connect to the router and ping the local ip address of
a server and printer without any problems over the VPN. I also have
terminal server configured to passthru the router so I can remotely
connect to a server also. Today I noticed that I could connect to the
VPN router using standard windows VPN client, ping the local address
of the router, http to the local address of the router, but could not
ping the server and printer. I then term service connected to the
server and could ping the printer from the server. I check the logged
on the dlink and noticed the traffic was getting dropped b/t my vpn
connection and the vpn router. All ping and net use requests were
dropped. I rebooted the router and it started all was working again.
What would cause this problem? The router was only one for 2 days
since the last reboot......
Re: VPN Advice...do I need a purchased static ip address on the external interface? ... >> Server then that server must have a been assigned a purchased static IP ... >> if I was to try and use Windows 2000 SBS as the server for the VPN,... >> If I used a router instead then the router would have this purchased IP ... > supports dynamic dns, then users connect to the dynamic dns name and ... (comp.dcom.vpn)
Re: Remote Web Desktop Connection - DHCP scope ...ping the server and the isp dns as well as access the 'net. ... the workgroup computers can access the internet through the server.... workgroup computer I can ping 192.168.16.2 but not the router 192.168.1.1 see ... I have a couple of questions, when setting up the two nics, I have not ... (microsoft.public.windows.server.sbs)
Re: vpn probl ... not to vpn server, so when workstations needed to reply to the ping requests ... they were trying to respond though their gateway that was the adsl router... static route 172.16.x..x pointing to vpn remote router in rras, ... (microsoft.public.windows.server.networking)
Re: Problem ... telephoned the office where the server was and asked her to re-boot the ... Once I saw the config of the VPN router there, I knew what to do on the ... on the remote site and see if they have the connection manager installed.... (microsoft.public.windows.server.sbs)
Re: Please Help Site-To-Site without ISA ... You can configure more than one site to site VPN connection on the ... You set up a new demand-dial interface and configure a new site to ... public IP of the VPN server at the second site on the front. ... to router connection.... (microsoft.public.windows.server.networking)
