Re: Identify Modular Phone Jack


"Jgolan" <jpgolan_at_earthlink_dot_net@xxxxxxx> wrote in message
news:bBEMf.114618$H54.113943@xxxxxxxxxxxxxxxxxxxxxxxxx
-------------------------------------


GlowingBlueMist wrote:




I am trying to locate a source of phone jacks that will fit in an
existing
equipment rack.

The panel presently has a combination of 6 and 8 pin jacks mounted in
it. I need to purchase some replacement jacks for the panel.

I removed one of the 6 pin jacks and it is labeled as a Lucent 22AB7 and
fits into a 5/8th by 11/16th inch hole in the panel.

I have been unable to locate a source for jacks that fit into this panel.

Can anyone point me to an online catalog that lists this jack or a
compatible replacement?

If it is Lucent it was replaced by Avaya and is now part of the CommScope
Systimax line is most likely part of their "M" series of jack which are
also used in their face plates. The tell tail sign is that it has two
locking tabs, one on each side. The panel that they are used with is part
of their M1000 series and held 24 jacks on 2 rows of 12 or the M2000
series.

Here is a link to one of their instruction sheets that shows the M1000 on
page 30 of the document
http://www.systimax.com/bp/documentation/engineering_guides/PowerSUM_GigaSPEED_XL_Installation_Guidelines.pdf

Here is a link to the M2000 instruction ***
http://www.systimax.com/documentation/inst/860_369_917.pdf

See if this is what you have.

Joe Golan, RCDD
--
##-----------------------------------------------##
Article posted with Cabling-Design.com Newsgroup Archive
http://www.cabling-design.com/forums
no-spam Web and RSS interface to your favorite newsgroup -
comp.dcom.telecom.tech - 3266 messages and counting!
##-----------------------------------------------##

Thanks for the information Joe,
The panel is one of the M1000 series.

With your info I have a much better chance of tracking down a source for the
modules, if they are still being sold.


.