Re: Nortel line side T1 to IPC system
- From: "Bob" <bobsjunkmail@xxxxxxxxxxxxx>
- Date: Fri, 28 Apr 2006 22:45:25 -0400
"Bob" <bobsjunkmail@xxxxxxxxxxxxx> wrote in message
news:jnA4g.20884$MM6.4791@xxxxxxxxxxxxxxxxxxxxxxxxx
That was wierd.... I don't have an answer for your question, but I also
"John Smith" <someone@xxxxxxxxxxxxx> wrote in message
news:IXz4g.13194$t61.3370@xxxxxxxxxxxxxxxxxxxxxxxxx
look at the dip switchs, there is one setting for ground start. It's
probably on.
<phonerjoe@xxxxxxxxxxx> wrote in message
news:1146229359.749844.26410@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi,
I have a Nortel line side T1 card connected to a IPC system. The T1 is
configured for D4/ AMI. I can make and receive calls however from the
turret when hearing ring back there's a hum between the ring cycles.
It only hums when there should be silence. As soon as the call is
answered the quality is fine. On the IPC side the lines are configured
as DIALTONE.
I already tried new equipment and cabling on both systems.
Does anyone know if any adjustments need to be made in the wire group?
Or what the issue could be?
Thanks........Joe
didn't intend for my post to be a reply.... Sorry.
.
- References:
- Nortel line side T1 to IPC system
- From: phonerjoe
- Re: Nortel line side T1 to IPC system
- From: John Smith
- Re: Nortel line side T1 to IPC system
- From: Bob
- Nortel line side T1 to IPC system
- Prev by Date: Third part I/P phones
- Next by Date: Re: Symposium / Callpilot cannot play internal prompts
- Previous by thread: Re: Nortel line side T1 to IPC system
- Next by thread: Nortel PP 15K UNI 3.1 rate of release
- Index(es):
Relevant Pages
|
|
