Re: unlock SIP 7960 phone with password set

On Aug 1, 5:54 pm, "swpa" <s...@xxxxxxxxxxxxxxxxxxx> wrote:
I got two 7960 phones that are running SIP and have a password locked
config, I need to unlock the phones, and reset them and make them sccp.

I tried to do the factory default sequence by power on, holding the #, then
123456789*0# but no luck, is there some other way to recover a password
locked 7960 to reset and restore to sccp?

I'm guessing you tried cisco123 as the password?
.

Relevant Pages

  • Re: how to cancel printing half way through
    ... and holding the reset or cancel button while ... restoring the power will clear the print job from the printer. ... I pushed the reset button on the printer. ... or even cancel the document. ...
    (microsoft.public.office.misc)
  • Re: How do you do a reset of a beige G3 tower?
    ... I told him to try holding in the power button for 15 seconds ... Try Control-Command-Power (the power button being the left-facing triangle ... there is a reset button inside the mini-tower ... shane at wonk dot demon dot co dot uk ...
    (comp.sys.mac.hardware.misc)
  • Re: Boss loop pedal problems any ideas/
    ... Is there a 'reset' button mentioned in the ... or switch on power whilst holding down one or two specific buttons ...
    (rec.music.makers.guitar.jazz)
  • Re: Wireless Routers for Linux?
    ... Mike McCarty wrote: ... hold the reset button for 30 seconds, ... while holding the button, waited 10 to 30 seconds, then ... the power. ...
    (Fedora)
  • Re: TZ Reset & Ive Tried Everything....
    ... Assuming your in a typical USA house, the power ... is also a very unlikely cause of any reset problems. ... line voltage that quickly drops to a low value almost instantaneously ... flippers resets it immediately. ...
    (rec.games.pinball)