Re: object-group syntax on catalyst 3750
- From: Doug McIntyre <merlyn@xxxxxxxxx>
- Date: 12 Mar 2009 03:28:04 GMT
Mikael <mikael.kermorgant@xxxxxxxxx> writes:
I've tried to defined an object-group on a 3750 catalyst switch in
order to write easier to read acls. Unfortunately, the command was not
recognized and I've found nothing indicating that it would be
supported.
Is this syntax impossible to use on this type of switchs ?
That was introduced in IOS at rev 12.4(20)T. (even if PIX/ASA has had
it forawhile). Since the newest switch code runs somewhere in 12.2, I
wouldn't expect them to support that command for many many years yet.
Guess cisco is expecting most security setup on an ASA box, not a switch.
.
- References:
- object-group syntax on catalyst 3750
- From: Mikael
- object-group syntax on catalyst 3750
- Prev by Date: Re: PIX 515e IOS 7.0(5) and when the Power goes out, the PIX reboots to Boot Monitor
- Next by Date: Re: console connections
- Previous by thread: object-group syntax on catalyst 3750
- Next by thread: Re: PIX 515e IOS 7.0(5) and when the Power goes out, the PIX reboots to Boot Monitor
- Index(es):
Relevant Pages
|
