Re: cisco wic-1adsl wan card connect to ISP


"Gabriele Beltrame" <belgab@xxxxxxxxxxxxx> wrote in message
news:4891c714$0$41661$4fafbaef@xxxxxxxxxxxxxxxxxxxxxx

Hi,

the command 'who' is just that... (who) (should give you something like the following:
Interface User Mode Idle Peer Address
Vi2 PPPoATM 00:00:00 192.168.100.1
Anyway since your PPP is in state LCP Listen (should be LCP Open and IPCP Open) you're
not connected.
As already suggested try a 'debug ppp <something>' (i.e. debug ppp packet, debug ppp
events, debug ppp negotiation, debug ppp authentication) to find out the root cause

thanks for your feedback Gabrielle. The lights on the adsl card appear to be doing the
right thing and I've been trying to connect all day, so I rang my isp who said their end
showed I hadn't even tried to log on (all day) so my router isn't even trying to connect,
which I find puzzling. How does one get the adsl card to initiate a connection? I tried
what you said and my cli responded thus: thanks for any further tips btw.
-----------------------------

router#debug ppp negotiation
PPP protocol negotiation debugging is on
router#debug ppp authentication
PPP authentication debugging is on
router#debug ppp events
^
% Invalid input detected at '^' marker.

router#debug ppp packet
PPP packet display debugging is on

router#who
Line User Host(s) Idle Location
* 0 con 0 idle 00:00:00

Interface User Mode Idle Peer Address

router#




.

Relevant Pages