Port Aggregation NM-4E

Hello
I have a C3620 (16F/64D) IOS 12.3(24) IP/FRW/IDS PLUS that is doing the firewall /nat device for my lan.

My network is this:

Edge Router C2650
"dmz switch" HP Procurve 2512

hp switch -> (DMZ/wan side) Eth1/0-----NM4E --{C3620} --NM-1FE-TX--- LAN C2950T-24

Can I bound all the four port of the NM-4E (or even just 2 or 3) to form a single port? The answer should be yes using the bridge group.

If I eventually replace the HP Switch with a Cisco Catalyst 2912XL, could I bound multiple ETH ports on the NM4E to aggregate bandwidth?
So I could transfer from the LAN (100mbit) to the DMZ side, at an higher speed?

Thank you




.

Relevant Pages

  • Re: Port Aggregation NM-4E
    ... router and you won't get more than about 20MB/s of throughput. ... "dmz switch" HP Procurve 2512 ... I bound multiple ETH ports on the NM4E to aggregate bandwidth? ... So I could transfer from the LAN to the DMZ side, ...
    (comp.dcom.sys.cisco)
  • Re: Firewall and DMZ topology
    ... attacker cannot spread his influence across the network. ... If the DMZ resides between the public Internet and the ... Should the DMZ be behind the LAN and not split off at the firewall, ... > The Gartner Group just put Neoteris in the top of its Magic Quadrant, ...
    (Security-Basics)
  • Re: Web portal security
    ... win2003 standard server with IIS, SSL enabled and will be placed on ... So I will be fwding port 443 in firewall to my DMZ port. ... Well, assuming you are going to use teh SQL database from SBS, you can ... subnet than my LAN and map one to one from firewall to dmz. ...
    (microsoft.public.windows.server.sbs)
  • Re: general question on design options
    ... Behind that I have my ISA, ... How do you get the VPN connections that terminate on the Cisco to get past ... DMZ and not the LAN. ...
    (microsoft.public.isa)
  • Re: Where to put the server
    ... Put the 2003 IIS Server in the DMZ. ... SBS box or another LAN server. ...
    (microsoft.public.backoffice.smallbiz2000)