Re: Multilink Frame Relay - which IOS supports it

Steven Proulx wrote:
I need to set MFR on a router but the two IOS version I tried don't support the commands. I tried IP 12.3(23) and IP PLUS 12.2(29b).
Does anyone know which IOS version I can use?

I am using 12.4(3G)
.

Relevant Pages

  • Multilink Frame Relay - which IOS supports it
    ... I need to set MFR on a router but the two IOS version I tried don't support the commands. ...
    (comp.dcom.sys.cisco)
  • Re: z/OS 1.10 announcement
    ... This new support is designed to allow you to use SDSF in both ... these commands when copying or moving lines that will have multiple ... A new z/OS UNIX interface to ISPF and TSO/E commands to allow them ...
    (bit.listserv.ibm-main)
  • =?ISO-8859-1?Q?New_System_Command_Script_Facility?=
    ... I'm currently finished writing a new replacement command script processor ... (at least that RACF thinks so, and better support for non-RACF sites). ... The IF-type commands now have ELSE processing ... non-scroll highlighted console message and BEEP until a specific JOB or TASK ...
    (bit.listserv.ibm-main)
  • Re: On "Recovery Time Limit" (TLER-like)
    ... See "SCT Error Recovery Control" in section 8.3.4. ... To confirm whether ERC is supported by the drive, ... Set supported) of word 206 in the Identify ... The ERC commands can be "tunnelled" inside SMART READ LOG and SMART ...
    (comp.sys.ibm.pc.hardware.storage)
  • Re: Cisco Workaround
    ... The key to a conspiracy theory is that the facts have ... The support money that cisco makes is just the point ... all collapse into a single IOS version. ... I think cisco got lucky that no one was very inventive ...
    (Security-Basics)