adding a switch to a switch stack
i am adding a switch to a 3750 switch stack that already has 2
switches in it. I am also running vtp in the network. I believe if i
add this new switch i will not have to concern myself with vtp(joining
it to the domain and adding the switch in transparent mode). Since
this would be controlled and set in the master switch in the stack.
Just confirming this. Thanks
.
Relevant Pages
- Re: TECH: EM Score Motor Question
... That sounds like you home switch stack is out of adjustment. ... tried to start a game from the coin door. ... score motor would not stop.....even at "game over" it wouldn't ...
(rec.games.pinball) - Tech EM: PatHand resets and plays once powerswitch is thrown?!
... There was a relay(coil, switch stack, and wires going from one end of ... corner...there's a relay with some sort of gear setup with 1 switch ... stack ontop that opens then closes every alternating time the coil ... pulls in...the 1 switch contact has a wire that goes nowhere, ...
(rec.games.pinball) - Re: EM - Gottlieb "Hot Shot" - game specific questions
... switch stacks that are buried behind others are hard to see. ... I ended up removing them, ... Don't lose the cam rider dogs for switch stackes on the A or C ... I usually take a few digital photos of a switch stack from different ...
(rec.games.pinball) - Re: EM - Gottlieb "Hot Shot" - game specific questions
... switch stacks that are buried behind others are hard to see. ... I ended up removing them, ... As long as you: ... I usually take a few digital photos of a switch stack from different ...
(rec.games.pinball) - 2950 switchport not in any vlan?
... Configuring a 2950T for ad-hoc ... must be able to connect to any of the access switch stacks in the ... Connected one port back to the floors switch stack and one port to a laptop. ...
(comp.dcom.sys.cisco) |
|
