console port

I've got a bunch of modems out there connected to console ports on
cisco routers. I know there is no way to reverse telnet to the console
port like you can to the aux port. I need to figure out some way to
send some modem AT commands to the modem. I tried doing a send con 0
then typing my command, but the banner that gets sent first is messing
things up. In fact if you connect a modem directly to a pc and then
copy and paste this in to a terminal session, you'll get nothing from
the modem:

***
***
*** Message from tty2 to all terminals:
***
ats0?

I've got a rs232 analyser online and see that it's getting to the
modem, but no go. Even pasting ***ats0?<CR> into a terminal doesn't
work. I need a way to blindly send data to the console port w/ no
banners. I don't need to read back any data, just send.

Surely others have run into this issue before. Appreciate any
insights.

Thanks in advance.

SPH

.

Relevant Pages

  • Re: Best way to secure management dial in
    ... Since console ports do not have modem ... ~> one user could dial in to the console, authenticate, then hang up, ... ~> The only really secure methods of permitting dialin access to your router ...
    (comp.dcom.sys.cisco)
  • Re: Best way to secure management dial in
    ... Since console ports do not have modem ... one user could dial in to the console, authenticate, then hang up, ... The only really secure methods of permitting dialin access to your router ...
    (comp.dcom.sys.cisco)
  • Re: minicom serial output
    ... >doesn't react and a multimeter accross the serial port shows that no data ... >initialisation / hangup commands. ... I already changed the modem initialisation string to ... present minicom configuration, go back to the default configuration ...
    (comp.os.linux.hardware)
  • Re: minicom serial output
    ... >>doesn't react and a multimeter accross the serial port shows that no data ... I already changed the modem initialisation string to ... >>'D' (one of the commands recognised by my device) and I can get my device ... > present minicom configuration, go back to the default configuration ...
    (comp.os.linux.hardware)
  • Re: recording voice through a independent TSP
    ... I have no experience in developing a wav driver. ... > so where will be my translations from TAPI commands to the PBX ... Unimodem can translate between TAPI and AT modem commands. ...
    (microsoft.public.win32.programmer.tapi)