Re: Updating 2900 switch

Tom,

It looks like you downloaded wrong image. Cisco has various "flavors" of
2924 switches, including LRE (Long Reach Ethernet) version. You should
download the latest IOS for 2900XL (2924XL) switch.

Good luck,

Mike
CCNP, CCDP, CCSP, Cisco Voice, MCSE W2K, MCSE+I, Security+, etc.
CCIE R&S (in progress), CCIE Voice (in progress)
------
Headset Adapters for Cisco IP Phones
www.ciscoheadsetadapter.com
www.headsetadapter.com

"Tom Linden" <tom@xxxxxxxxxxxxxx> wrote in message
news:op.t0t078qchv4qyg@xxxxxxxxxxxxxxxxx
What does following message mean, which was at the end of the update?

C2900XL INIT: Complete

00:00:42: %SYS-5-CONFIG: Configured from NVRAM by console
00:00:42: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) C2900XL Software (C2900XL-C3H2L9S-M), Version 12.0(5)WC17,
RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Tue 13-Feb-07 15:28 by antonino
00:00:42: %IMAGE_MISMATCH-3-MALIBU_IMAGE_MISMATCH:
LRE firmware not supported by switch hardware.
Please download a non-LRE image.


.

Relevant Pages

  • Download IOS FROM Switch
    ... is it possible to download the Cisco IOS FROM the switch and ... We have several 2950 LRE with different IOS version and would like to have ...
    (comp.dcom.sys.cisco)
  • Re: Cat 2924
    ... Copyright 1986-2004 by cisco Systems, ... BOX in both H/W and S/W, compared to a C2924-XL Switch... ... FastEthernet0/1 failed front-end loopback test ... to make the port configuration "visible", you need to apply 2 commands ...
    (comp.dcom.sys.cisco)
  • Re: VPN over wireless
    ... I personally use Cisco since I am Cisco Certified. ... Support with a Cisco Switch it would work. ... on my network - and no success. ... You will still the need the Router to issue DHCP and ...
    (microsoft.public.windows.server.sbs)
  • Re: Cat 2924
    ... Copyright 1986-2004 by cisco Systems, ... BOX in both H/W and S/W, compared to a C2924-XL Switch... ... FastEthernet0/1 failed front-end loopback test ... to make the port configuration "visible", you need to apply 2 commands ...
    (comp.dcom.sys.cisco)
  • Re: Brocade / Cisco interop issue
    ... By bouncing the host port connected to the Cisco switch you're causing the ... to see if this removes the Brocade failure. ...
    (comp.arch.storage)