Re: 2509 Console Server


It can be done.

This type of setup is called "reverse telnet"

in telnet we go from a async terminal to a TCP-based telnet session to
the desired target destination.

In reverse telnet we go from a telnet-session to async output - int
his case to an async console port on a router.

So in reverse telnet we need an IP address and a port number.

The IP address is simple and is either an Ethernet interface or
loopback interface address on the terminal server

The port is a mapping from the line numbers seen by the show line
command and takes the form 20xx where xx is the line number.




.

Relevant Pages

  • Re: Alpha Console Access Question
    ... reverse telnet to port 323 of the SMC for OPA0: ... Unofficial Affordable OpenVMS Home Page: ... Unofficial OpenVMS Hobbyist Support Page: ...
    (comp.os.vms)
  • Re: Reverse Telnet from 2610
    ... references reverse telnet via port 2000+n (n being the port number of ... Having problems using reverse telnet. ... Using the AUX port on a 2610 connecting to the Console port of a 3550 ...
    (comp.dcom.sys.cisco)
  • Re: Alpha Console Access Question
    ... This is on ES47 systems but I think they are ... reverse telnet to port 323 of the SMC for OPA0: ... reverse telnet to port 23 of the SMC for MBM access ...
    (comp.os.vms)
  • Re: Firewall hits/unknown ports
    ... Subject: Firewall hits/unknown ports ... You might look at what they're using for a "source" port - ... I've seen numerous "reverse http" and "reverse telnet" scans, ...
    (Incidents)