Re: Cat-6506 Sup 720 and FWSM

On Aug 8, 8:27 am, "Martin Bilgrav" <bilgravCUTTHIS...@xxxxxxxxxx>
wrote:
Hi,

I got one of my FWSM that will not boot.
upon insertion i get the sho mod status of other and diags unknown.
after 15 min I get log entry : power to module in slot 2 set off (module
failed SCP dnld) and it goes in power down mode.

under no condition can I get a chance to issue a rest command to get to
maintenance partion on cf:1

What would the correct way to upgrade cf:1 be ?
I follwed the CCO guide but no luck, as the device is power-down and upon
reinsertion I can not get it to accecpt any hw-module reset commands.

I think RMA ...
Are there any remote commands that might help ? or ...

regards

Martin Bilgrav

Sounds like a power or fan problem. Have you checked the requirements
of the blade and/or limitations of whatever power supplies you are
running? You can't reset a blade that is not powered up, and the
chassis has to be shutting it down for a reason. I'd tend to think
power as fan issues are usually only for sup720s and up....plus you'd
get an error message.

.

Relevant Pages