Re: Optimized Edge Routing

<ahazan80@xxxxxxxxxxx> ha scritto nel messaggio
news:1185831033.982851.51320@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I'm looking to run Optimized Edge Routing in conjunction with BGP.
Is that possible?
Can I run it (with BGP) on a 2811? 2821?
How much DRAM would i need for both (the BGP is Full Routes)?
Does the router have to be running NAT to do OER? We prefer to keep
NAT off the router.

Thanks

Hi,

As far as I know (and I know very little) OER "simply" modifies the routing
table by monitoring some prefixes (using SLA features); it is protocol
independent and do not need NAT and it consumes memory proportionally to the
prefixes it manages. It is supported even on a low-end routers so the 28xx
are supported as well.

Regards,
Gabriele


.

Relevant Pages

  • Re: BGP Failover
    ... >> We want to act as backup for each other so if our core router dies theirs ... > Setup a BGP session on each side and announce your prefixes to each other. ... Assuming one router fails the world will find the AS through the partner, ...
    (comp.dcom.sys.cisco)
  • Re: Static Translations Disappearing
    ... this router and see if they have the same behavior. ... you are running into a NAT bug. ... It wouldn't hurt to change IOS and ... ....where it just shows all translations being dynamic (0 static, ...
    (comp.dcom.sys.cisco)
  • Re: IP Route Tables - Point to Point Connection - Only Routing 1 way
    ... Your ksshorley1 router is performing network address translation (NAT) on ... default route command. ...
    (comp.dcom.sys.cisco)
  • Re: Cisco 1700 Router
    ... I must consider your modem to be a router which provides PPPoE, DNS proxy ... and NAT services. ... This default route points out interface Ethernet0, ...
    (comp.dcom.sys.cisco)
  • Re: NAT is not a mechanism for securing a network.. but.. HELP!
    ... > Linksys NAT router at the time and the machines behind the router ... > responded to the ping test. ... > Not once did the Linksys NAT router in its syslog using Wallwatcher ... "if the firewall responds to pings, there is an easy path for hackers into the network" ...
    (comp.security.firewalls)