1242AG and fa 0 when using vlan

I use the web interface of the 1242AG access point to set up the
wireless LAN using VLAN and connect it to one trunk port of the
router, which also acts a the dhcp server for the access point.

After configuring the AP, I reload it and my notebook can get an ip
and wirelessly access the network thru that AP. But the interface fa
0 never gets an IP address from the DHCP server. I also try setting an
IP manually for the fa 0, but I cannot ping it at all.

( The purpose of setting the ip address for the ip is to be able to
access it remotely. )

Any advice how to set it work correctly is greatly appreciated.

Below is the config of fa 0 and fa 0.5 ( VLAN 5 is used in this case )

interface FastEthernet0
ip address 192.168.243.100 255.255.255.0
no ip route-cache
duplex auto
speed auto
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface FastEthernet0.5
encapsulation dot1Q 5
no ip route-cache
no snmp trap link-status
bridge-group 5
no bridge-group 5 source-learning
bridge-group 5 spanning-disabled
!


DT

.

Relevant Pages