Re: Not able to hit 2950

In article <1183056699.277744.264590@xxxxxxxxxxxxxxxxxxxxxxxxxxx>, kinnamonb@xxxxxxxxxxxxxxxxx writes:
On Jun 28, 1:44 pm, Trendkill <jpma...@xxxxxxxxx> wrote:
On Jun 28, 2:37 pm, kinnam...@xxxxxxxxxxxxxxxxx wrote:

I just put a new 2950 on the network. The core is a 4507R. I already
had 46 2950's on the network. ON the new one I pasted the configue
into it from another switch. I did change the ip before I pasted it
in. The switch is working fine, passing traffic to the correct vlans
by port, but I am unable to telnet by ip in to it, and I can not ping
it either. The running configue shows correct ip. Any ideas?

Subnet mask? Is the IP in the right vlan? Does it have the correct
default gateway? Can you ping/telnet from the next hop?

yes correct subnet.Switchs get all vlans we vlan form the ports. The
ip is in the correct mangament range 10.1.32.*
Yes correct Gateway, No can not ping from any hop or even if I am
plugged into the switch its self

The question was whether the management IP is in the right VLAN,
not whether it was the right management IP. (Though it is good
to know that the management IP is proper).

If, for instance, the management VLAN is VLAN 1 and your router's
management ip is on interface VLAN 10 then you'll have problems.

Also, since you say you pasted the configuration in, are you sure
that the VLAN x interface is not "shutdown". By default any
interfaces created by pasting in new configuration information
are "administratively down". If this is the issue, the fix is
to console in and:

config t
interface VLAN 10 (assuming you're using VLAN 10 for management)
no shut


.

Relevant Pages

  • Allied Telesis AT-9000/24 Ethernet switch management can be accessed from all VLANs.
    ... The AT-9000/24 Ethernet switch's management can be accessed ... from any VLAN which has been configured to switch. ... only available from management VLAN and with AT-9000/24 ... Port setting can be reset easily after this. ...
    (Bugtraq)
  • Re: Not able to hit 2950
    ... The switch is working fine, passing traffic to the correct vlans ... The running configue shows correct ip. ... The question was whether the management IP is in the right VLAN, ...
    (comp.dcom.sys.cisco)
  • Re: Restricting Admin Access to 2924
    ... requests on port 1 of the switch and ignore any requests on any other ... You need to configure layer-3 management access control based on the ... VLAN interface. ...
    (comp.dcom.sys.cisco)
  • Re: Not able to hit 2950
    ... The switch is working fine, passing traffic to the correct vlans ... The running configue shows correct ip. ... Yes but is the ip address on the right vlan? ... What vlan is the management interface on on the other 2950s? ...
    (comp.dcom.sys.cisco)
  • Re: nortel Baystack 5520-24T ethernet switch
    ... > I have been praticing the configuration of this ethernet switch for a ... > while and it kicked me off while I was making some VLAN ... > static IP to my laptop when I try to connect to the switch ... The switch management is setup by default on VLAN 0 or 1. ...
    (comp.dcom.sys.nortel)