standby ASA doesn't learn ospf routes
- From: linguafr <billf@xxxxxxxxxxxxxxxx>
- Date: 30 May 2007 11:24:27 -0700
This occurred as of an interim upgrade from
6 8312832 Feb 23 2007 11:46:48 asa722-k8.bin
to
11 8349696 May 29 2007 17:44:30 asa722-22-k8.bin
Cisco doc indicates this might be expected behavior for 7.2(2),
however the standby definitely had ospf routes prior to this
incremental upgrade. I know this for a fact because I was able to get
to it from other than the local inside net prior to the upgrade.
Anyone else observe this? If this is expected behavior as per the
doc, how is one supposed to access the standby from a remote net? I
just assumed that expected behavior was for the standby to rec ospf
routes from the primary, but not broadcast any.
http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008063b31a.html#wp1052476
.
- Prev by Date: Re: Configuring VLANs on Catalyst 2960G
- Next by Date: Access list and How to use It ?
- Previous by thread: Configuring VLANs on Catalyst 2960G
- Next by thread: Access list and How to use It ?
- Index(es):
Relevant Pages
|
