Standby ASA stops doing ospf after upgrade

From: linguafr <billf@xxxxxxxxxxxxxxxx>
Date: 29 May 2007 22:04:21 -0700

after upgrading fover pair to asa722-22-k8.bin on reboot i see this on
standby. no ospf routes in table

sfo2-asa-01> .
Detected an Active mate
Beginning configuration replication from mate.
DHCPRA: Deleting last server while DHCPRA is running. No relaying will
be done.
Device Manager image set, but unable toAllowing OSPF process to run
for a while
to complete config sync.
nAllowing OSPF process to run for a whifle to complete config syinc.
d disk0:/asdm521-54.bin
nat 0 0.0.0.0 will be identity translated for outbound
Allowing OSPF process to run for a while to complete config sync.
Allowing OSPF process to run for a while to complete config sync.
Allowing OSPF process to run for a while to complete config sync.
Allowing OSPF process to run for a while to complete config sync.
INFO: Only classful networks will be redistributed
End configuration replication from mate.
sfo2-asa-01> en

running debug ospf on the standby i see

OSPF: Input packet ignored.
OSPF: Input packet ignored

.

Prev by Date: Haw to monitor Cisco switches
Next by Date: Re: Haw to monitor Cisco switches
Previous by thread: Haw to monitor Cisco switches
Next by thread: Cisco SB 101
Index(es):
- Date
- Thread

Relevant Pages

Re: OSPF routes not in routing table
... 7206 and each interface uses an "ip unnumbered loopback X", ... sample non-working config (note that my cvs config puller removes the ... ip ospf authentication message-digest ... Neighbor Count is 1, ...
(comp.dcom.sys.cisco)
Re: Problems of configuration command
... redistribute from the OSPF area 0 such that the RIP can be communicate ... router bgp 100 ...
(comp.dcom.sys.cisco)
Re: ospf router-id incident
... I cleared the ospf process and manually set the new router-id to ... My understanding was the router selects the local ip, ... OSPF router id (RID) ...
(comp.dcom.sys.cisco)