Re: Frame Relay Lan routing between sites help needed

kjkearney@xxxxxxxxx writes:
Well the problem is I cannot even ping the FastEthernet IP address of
the remote router from the main router. Until I can get that to
happen workstations will not work either.

Check to make sure the line protocol is up on your fastethernet on
that side. If line protocol is down, you won't be able to ping.

Otherwise, seeing the 'show route' for each router would be more
helpful than seeing configs at this point.

Doing the static routes that you had listed should work fine.

You seem to have connectivity across the Frame-Relay.



.

Relevant Pages

  • RE: VPN to SBS through Comcast router
    ... The only thing I can find is to open TCP/UDP port 47 ... "What's GRE?". ... >> workaround for the hardware router which is not supporting PPTP connection. ... GRE is a client protocol of IP ...
    (microsoft.public.windows.server.sbs)
  • Re: What provides default router via DHCP?
    ... >> same thing can be done better using RIP. ... I'd also note that IPv6 has a similar router discovery mechanism. ... protocol and without substantial changes. ... if you run DHCP as a client on Solaris and the DHCP ...
    (comp.unix.admin)
  • 2503/WS-1103 intermittant ping
    ... I installed a 2503/WS-1103 which is a catalyst 3200 with a router ... blade installed on my network. ... BRI0 is administratively down, line protocol is down ... IP fast switching on the same interface is disabled ...
    (comp.dcom.sys.cisco)
  • 500 Networking Interview questions for routers , firewall , VPN and lot
    ... Can you explain IP protocol? ... On what layers do router, switched, bridges and hubs operate? ... Can you explain how in detail how routing table looks like? ... How can you see route tables on the router? ...
    (microsoft.public.pocketpc.wireless)
  • 500 Networking Interview questions for routers , firewall , VPN and lot
    ... Can you explain IP protocol? ... On what layers do router, switched, bridges and hubs operate? ... Can you explain how in detail how routing table looks like? ... How can you see route tables on the router? ...
    (microsoft.public.win2000.networking)