SNMPv3 and Community String Indexing

hi,
how can I realize csi with snmpv3?

read mac addresses from vlan 3 with snmpv2 :
snmpwalk -v 2c ... -c public@3 switchip oid

when i read the switch with username and password and v3, i only
receive macs from the default vlan.


thanks, f-d

.

Relevant Pages

  • RE: Different terms for the same or more secure?
    ... A SWITCH is a box with a bunch of interfaces and a MAC address ... has seen that packet's source MAC address show up at interface X, ... of those groups is a VLAN. ...
    (Security-Basics)
  • RE: [fw-wiz] Link level security with static arp tables
    ... Would it be easier to solve this at a switch? ... So a VLAN could isolate the traffic. ... I could disable arp on eht0 and use static arp tables in the gw, ... will not be able to find it's MAC. ...
    (Firewall-Wizards)
  • Re: arp-proxy
    ... address allocated by DHCP ... the MAC address for cust1 must never appear as a source MAC ... a broadcast from the service subnet should appear on all customer VLANs ... to the correct customer VLAN ...
    (freebsd-net)
  • Re: arp-proxy
    ... Not a big fan of Linux though. ... >> separate vlan trunked. ... > IIUC, you want to do some kind of NAT of MAC addresses, this is not ... > simple router which has one route for each customer pointing to the ...
    (freebsd-net)
  • Re: 2950 empty mac address table
    ... >>One other VLAN was configured, but no interfaces were bound to it. ... > for the attached switches all look correct? ... > and do the replies have the expected MAC? ... config and full mac tables. ...
    (comp.dcom.sys.cisco)