404 trying to access pdm

Trying to get pdm working on our PIX 6.2 Firewall, but not having much
luck. I have it enabled and set up to accept connections from my
workstation's IP address. I get the warnings about the certificate
and, after I accept it, I'm prompted for credentials. When I enter my
name and password, though, I just get a 404 "Not Found" error.

Any ideas?

.

Relevant Pages

  • Re: [fw-wiz] Scheduling PIX commands
    ... I suggested being within ear shot of the rack containing the Firewall at 2 ... dependent of monitoring the state of connections (back to the client and / ... clearing the xlate table, i dont see how that could go very wrong. ... We've just made some changes to our PIX config, ...
    (Firewall-Wizards)
  • Re: VPN
    ... I have now configured protocol 47 gre in my pix to permit ... external router/ firewall setup at home. ... >> connect to a computer running windows 2000 professional ... >> I have enabled the VPN to accept connections in the ...
    (microsoft.public.win2000.networking)
  • Re: Protecting PIX Firewall at the Perimeter Router
    ... Put an OpenBSD firewall in front of the PIX. ... >> PIX will be doing NAT, protecting DMZ machines, and IPSec connections. ...
    (Security-Basics)
  • RE: Firewall in HA: how VRRP works?
    ... Depends on the firewall. ... In the PIX there are two failover type. ... failover does not failover the connections. ...
    (Security-Basics)
  • Re: What is the Pattern here ?
    ... These are all Dialup Connections that I had no connection with at the time. ... It's obviously an enormous security hole, ... > and a real firewall box. ...
    (comp.security.firewalls)