Block internal IP with Cisco PIX 501

Can I block a specific internal IP or range of IP from accessing the
outside interface ie internet on a PIX 501.
If so, I was hoping for a little help with the command line.
Thanks in advance!

.

Relevant Pages

  • [fw-wiz] RE: PIX v7: routing without NAT
    ... Create another private network and assign it to your inside interface ... for the servers that need access to it from the internet. ... servers behind my PIX 515E to use the public IP ...
    (Firewall-Wizards)
  • RE: [fw-wiz] PIX DMZ inter-access via outside IP address
    ... not from the DMZ back to the DMZ using the Internet address. ... interface would get ignored by the router because they were assumed to be ... > destination addresses. ... The alias command will solve this problem. ...
    (Firewall-Wizards)
  • Re: Surfing the internet WHILST using a VPN connection (PIX 513)
    ... I don't have any experience with the Cisco VPN client, ... Once on the network users wish to browse the internet. ... There is a PIX 515, and a re-spun version of that called the PIX 515E. ... a seperate physical interface that is also connected to the ISP. ...
    (comp.dcom.sys.cisco)
  • Re: Problem configuring NAT to share Internet Connection
    ... One of my NICs in the server connect to a DSL ... modem and it connects to internet. ... > interface, that connects to the DSL modem, LAN interface, that connects to ... >> 7.- To connect server to Internet, I create a new network connection. ...
    (microsoft.public.win2000.ras_routing)
  • Re: Surfing the internet WHILST using a VPN connection (PIX 513)
    ... You are basically bridging the internet and your corporate LAN. ... locally using your ISP connection and send traffic over the VPN at the ... There is a PIX 515, and a re-spun version of that called the PIX 515E. ... a seperate physical interface that is also connected to the ISP. ...
    (comp.dcom.sys.cisco)