Re: Routing Question - How to send default internet traffic to PIX and VPN traffic from router out internet
- From: roberson@xxxxxxxxxxxx (Walter Roberson)
- Date: Tue, 27 Feb 2007 22:00:31 GMT
In article <1172602709.140307.22490@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
Evolution <evolution.of.rod@xxxxxxxxx> wrote:
This is the scenario:
I have a network with Subnet: 192.168.1.0/20
A Cisco 1841 Exists as the default Gateway: 192.168.1.1 Fa0/1, Fa0/2
is 66.43.54.111
A PIX 501 Exists to filter traffic: 192.168.1.254 Inside, 66.43.55.20
Outside
The route so far is 0.0.0.0 0.0.0.0 192.168.1.254, This sends all
traffic out through the PIX 501
If I want the router to be able to access the internet, but not
through the PIX 501, how would I set this up. The next hop router for
66.43.54.111 is 66.43.54.1.
I'm confused. Do you have the router and PIX in parallel, both
connected to an outside device (e.g., a switch or second router),
or are the two connected to different ISPs, or are the two in series??
.
- References:
- Prev by Date: Re: question on the internal IP address design
- Next by Date: Re: Roaming on three Cisco Aironet (AIR-AP-1231G)
- Previous by thread: Routing Question - How to send default internet traffic to PIX and VPN traffic from router out internet
- Index(es):
