Re: PIX 515E DMZ with Public IP and Inside with Private IP

On Feb 27, 4:58 pm, "esud...@xxxxxxxxx" <esud...@xxxxxxxxx> wrote:
Hi, I have T1 with a class C that is subnetted into two for Outside
and DMZ network with Inside using private IP address. My question is
how do I configure the DMZ to use the public address without NATing to
the Outside IP address. All the config sample I found uses Outside
public IP address NATed to the DMZ private network? i.e., DMZ with web
server using IP address from Outside network.http://www.cisco.com/warp/public/110/mailserver.html

I am looking for sample configuration that uses public IP on the
Outside, public IP on DMZ and Private IP on the Inside.

TIA,
BK

Actually you can use both for webservers inside, you can statically
nat the webserver public ip to a private and both local and public
users will have access to the webserver.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml

Or you can not to nat using command nat 0.

GoodLuck
Andy.

.