Re: Need help with PIX commands

Thank you! I will try it this weekend!


mcaissie wrote:
Your commands are ok but i am quit sure the reboot is not
needed for that, and you don't have to do the "no" line.

So the following would be enough ;

isakmp identity hostname <enter>
wr mem <enter>

but feel free to reload if you want to be sure




<chrismtoth@xxxxxxxxx> wrote in message
news:1158330138.357919.88240@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I did a 'sh running config' command and I see that I have:
isakmp identity address

I imagine my VPN issues may clear up if I change it to 'isakmp identity
hostname'

Should I do:
no isakmp identity address <enter>
isakmp identity hostname <enter>
wr mem <enter>
reload

That's all I need to change, right?

Thanks!


.

Relevant Pages

  • Re: Need help with PIX commands
    ... isakmp identity hostname ... wr mem ... but feel free to reload if you want to be sure ...
    (comp.dcom.sys.cisco)
  • Re: Cisco VPN Client issues with PIX 506e
    ... do isakmp identity address and hostname ... commands work together/? ... site to site tunnels in my firewall. ... isakmp identity hostname ...
    (comp.dcom.sys.cisco)
  • Re: Cisco VPN Client issues with PIX 506e
    ... Well I tried the 'clear ipsec sa' and it didn't work. ... 'reload' and then the client was able to log in again and use the VPN. ... So I should still do the 'configure isakmp identity hostname'? ... now configure isakmp identity hostname ...
    (comp.dcom.sys.cisco)
  • Re: Cisco VPN Client issues with PIX 506e
    ... I imagine my VPN issues may clear up if I change it to 'isakmp identity ... isakmp identity hostname ...
    (comp.dcom.sys.cisco)
  • Need help with PIX commands
    ... I imagine my VPN issues may clear up if I change it to 'isakmp identity ... isakmp identity hostname ...
    (comp.dcom.sys.cisco)