Re: Cisco 2610 Router

There seems to have some problem with OS version. Look into the OS
version, install a different version and see if it works.

BR,
Mujahid

ryu1 wrote:
I did copy the running-config to startup-config, and I double check by
sh startup-config to verify the config has been copied. But on the
other hand, even if I have never configure the router, it will at least
show what interface I have on my router, like ethernet, serial, or
controller T1, right? It just won't have any configuration when typing
sh config. It looks like my router didn't detect the controller T1 now,
I don't think I will damage the card by simply plugging in a cable,
right?

Thanks,
Alan

.

Relevant Pages

  • Re: Cisco 2610 Router
    ... I did copy the running-config to startup-config, ... sh startup-config to verify the config has been copied. ... other hand, even if I have never configure the router, it will at least ... It looks like my router didn't detect the controller T1 now, ...
    (comp.dcom.sys.cisco)
  • Re: UDP Broadcast traffic?
    ... startup-config, and restarted the router. ... I will send a copy of my config to you directly, ... deny udp host 192.168.11.10 host 239.192.2.65 eq 2222 ...
    (comp.dcom.sys.cisco)
  • Re: Newbie first-time install advice: Highpoint Rocket 133SB
    ... > router and a working NIC you have working internet. ... > Chances are VERY good the Rocket 133SB uses a standard controller. ... >> someone can tell me how to finesse it to work with my DSL modem. ... That is what debian-user is here for. ...
    (Debian-User)
  • Re: Probleme with nm-16am v1.0
    ... the router worked perfectly until electrical outage then the tow cards ... sh start - displays the time the config was last saved *however* ... modem country microcom_hdms europe ... interface FastEthernet0/0 ...
    (comp.dcom.sys.cisco)
  • Re: Adding site to Domain, question about configuring before deploy
    ... I have a remote access controller setup that allows me to attach ... to the console w/o the machine be attached to the network. ... >> showing different IP subnets and there will not be a router between them ...
    (microsoft.public.win2000.active_directory)