Re: dhcp cisco806 basic setup question/problem...



1. Please post izOS version in use


2. Suggested config change


! configure default route

ip route 0.0.0.0 0.0.0.0 dhcp



3. debug DHCP

conf t
logging buffer 10000 debug
no logging console
end

wri mem


clear log
debug ip dhcp server events
debug ip dhcp server packets

Post debug output

.

Relevant Pages

  • Re: 1720 and comcast
    ... logging buffer 10000 debug ... Verify that the "outside" interface connected to the cable modem is ... Enable DHCP debugging ...
    (comp.dcom.sys.cisco)
  • NIC fails in RELEASE build CE 5.0
    ... VMINI driver in a debug build it works fine. ... In the release build, DHCP ... I enabled serialDebug, but kept: ...
    (microsoft.public.windowsce.platbuilder)
  • Re: NIC fails in RELEASE build CE 5.0
    ... it isn't included in the registry anywhere. ... And in the SerialDebug version it is never loaded. ... VMINI driver in a debug build it works fine. ... In the release build, DHCP ...
    (microsoft.public.windowsce.platbuilder)
  • Re: 871W Cannot Get DHCP Address - Cable Modem
    ... Enable internal logging on router ... logging buffer 10000 debug ... Turn on debugging for DHCP requests to ISP ...
    (comp.dcom.sys.cisco)
  • Re: NIC fails in RELEASE build CE 5.0
    ... VMINI driver in a debug build it works fine. ... IMGNOKITL=1 (UN-check box - Build Options) ... The CE board sends a "DHCP Discover message", ...
    (microsoft.public.windowsce.platbuilder)