EIGRP: Default Route is not propagating

Hub and Spoke network.
3700 hubFrame Relay

Sites are all 1721
Stub mode

I have a route map in a router pointing to my default gateway. I see
the route propogated to the 3700 using "Sh ip eigrp top 0.0.0.0
0.0.0.0, however it does not make it to the remote sites. All other
routes are distributed to EIGRP.

Any ideas?

There are no acl's involved, and otherwise EIGRP is working normally.

.

Relevant Pages

  • Re: BGP & EIGRP Routing Issue
    ... EIGRP. ... accidentally advertise these routes back to me. ... The route is in the BGP table but not in the routing table. ...
    (comp.dcom.sys.cisco)
  • Re: BGP & EIGRP Routing Issue
    ... EIGRP. ... accidentally advertise these routes back to me. ... The route is in the BGP table but not in the routing table. ...
    (comp.dcom.sys.cisco)
  • Re: Cant Ping From Router
    ... Where is it getting that static route. ... both static and EIGRP at the same time? ... float all the statics ... Temp IP addr: 12.214.124.4 for peer on Interface: FastEthernet0/1 ...
    (comp.dcom.sys.cisco)
  • Re: Cant Ping From Router
    ... Where is it getting that static route. ... both static and EIGRP at the same time? ... float all the statics ... ESP_South#sh ip route dhcp ...
    (comp.dcom.sys.cisco)
  • EIGRP: Default Route is not propagating
    ... I have a route map in a router pointing to my default gateway. ... routes are distributed to EIGRP. ...
    (comp.dcom.sys.cisco)