Re: 2503/WS-1103 intermittant ping

Howard Huntley <hhuntleyjr@xxxxxxxxxxx> wrote:

I installed a 2503/WS-1103 which is a catalyst 3200 with a router
blade installed on my network. The router seems to perform OK except
when I ping the ethernet connection, I only get back every other ping.
The 7 cisco 2500 routers are connected in a circle using serial
connections. Also, there is only one gateway listed in the "sh ip
protocols". All other routers in the circle show two gateways listed
in the "SH IP protocols" display. Configs listed below.
*****************************************************************************************************************
User Access Verification

Password:
Cis2503d>sh ver
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-I-L), Version 11.2(2)P, SHARED PLATFORM
RELEASE
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Mon 11-Nov-96 23:04 by vprasad
Image text-base: 0x030217BC, data-base: 0x00001000

ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
ROM: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE
SOFTWARE ()

Cis2503d uptime is 20 hours, 21 minutes
System restarted by power-on
System image file is "flash:c2500-i-l.112-2.P", booted via flash

cisco 2500 (68030) processor (revision N) with 2048K/2048K bytes of
memory.
Processor board ID 07090021, with hardware revision 00000000
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Basic Rate ISDN software, Version 1.0.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read ONLY)

Configuration register is 0x2102

Cis2503d>sh ip protocols
Routing Protocol is "igrp 10"
Sending updates every 90 seconds, next due in 63 seconds
Invalid after 270 seconds, hold down 280, flushed after 630
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
IGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
IGRP maximum hopcount 100
IGRP maximum metric variance 1
Redistributing: igrp 10
Routing for Networks:
192.168.7.0
192.168.8.0
192.168.12.0
192.168.13.0
192.168.14.0
192.168.9.0
Routing Information Sources:
Gateway Distance Last Update
192.168.13.1 100 00:01:16
Distance: (default is 100)

Cis2503d>

Cis2503d>sh ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B -
BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * -
candidate default
U - per-user static route, o - ODR

Gateway of last resort is 0.0.0.0 to network 0.0.0.0

I 192.168.9.0/24 [100/162250] via 192.168.13.1, 00:00:54, Serial1
I 192.168.10.0/24 [100/166350] via 192.168.13.1, 00:00:54, Serial1
I 192.168.11.0/24 [100/166350] via 192.168.13.1, 00:00:54, Serial1
I 192.168.12.0/24 [100/168250] via 192.168.13.1, 00:00:55, Serial1
C 192.168.13.0/24 is directly connected, Serial1
C 192.168.14.0/24 is directly connected, Serial0
I 192.168.0.0/24 [100/164350] via 192.168.13.1, 00:00:55, Serial1
I 192.168.1.0/24 [100/164250] via 192.168.13.1, 00:00:55, Serial1
I 192.168.3.0/24 [100/162350] via 192.168.13.1, 00:00:55, Serial1
I 192.168.4.0/24 [100/160250] via 192.168.13.1, 00:00:55, Serial1
I 192.168.5.0/24 [100/168313] via 192.168.13.1, 00:00:55, Serial1
I 192.168.6.0/24 [100/160350] via 192.168.13.1, 00:00:55, Serial1
C 192.168.7.0/24 is directly connected, Ethernet0
I 192.168.16.0/24 [100/166250] via 192.168.13.1, 00:00:55, Serial1
S* 0.0.0.0/0 is directly connected, Serial0
Cis2503d>


Cis2503d>
Cis2503d>sh ip int
BRI0 is administratively down, line protocol is down
Internet protocol processing disabled
BRI0:1 is administratively down, line protocol is down
Internet protocol processing disabled
BRI0:2 is administratively down, line protocol is down
Internet protocol processing disabled
Ethernet0 is up, line protocol is up
Internet address is 192.168.7.1/24
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is enabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP multicast fast switching is enabled
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
Probe proxy name replies are disabled
Gateway Discovery is disabled
Policy routing is disabled
Network address translation is disabled
Serial0 is up, line protocol is up
Internet address is 192.168.14.1/24
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is enabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP multicast fast switching is enabled
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
Probe proxy name replies are disabled
Gateway Discovery is disabled
Policy routing is disabled
Network address translation is disabled
Serial1 is up, line protocol is up
Internet address is 192.168.13.2/24
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is enabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP multicast fast switching is enabled
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
Probe proxy name replies are disabled
Gateway Discovery is disabled
Policy routing is disabled
Network address translation is disabled
Cis2503d>


C:\>ping -n 20 192.168.7.1

Pinging 192.168.7.1 with 32 bytes of data:

Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=74ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=70ms TTL=25
Request timed out.
Reply from 192.168.7.1: bytes=32 time=69ms TTL=25
Request timed out.

Ping statistics for 192.168.7.1:
Packets: Sent = 20, Received = 10, Lost = 10
Approximate round trip times in milli-seconds:
Minimum = 69ms, Maximum = 74ms, Average = 69m

.

Relevant Pages

  • Re: Using Remote Desktop From an SBS Domain
    ... After I thought about needing 3389 forwarded on my router to allow me to ... Remote Desktop "out" from a workstation on my SBS network to a host XP ... Hopefully next week I can attempt a connection while my ISP watches the ...
    (microsoft.public.windows.server.sbs)
  • Re: Connection from remote computer to network SQL Server
    ... There is no firewall on the W2K machine acting as the SQL server. ... I tried making the SQL machine a "trusted" on the router. ... connection works. ... To find the IP address of your computer inside the network, ...
    (microsoft.public.access.adp.sqlserver)
  • Re: Unable to obtain a server- assigned IP address Try again later or enter an IP address in Net
    ... I can go to Control Panel - Network and Internet Connections - ... If yours is not a subset of your router, ... I have a LINKSYS router (4 port connection) - I have my cable modem ...
    (microsoft.public.pocketpc)
  • Re: Connection from remote computer to network SQL Server
    ... There is no firewall on the W2K machine acting as the SQL server. ... I tried making the SQL machine a "trusted" on the router. ... connection works. ... To find the IP address of your computer inside the network, ...
    (microsoft.public.access.adp.sqlserver)
  • Re: Loss of Connectivity on Only One PC on a LAN
    ... When you ran the Network Setup Wizard, ... The original setup of the LAN was done entirely by the user of the other PC on that LAN in July. ... I use a LAN connection which consists of two PCs each connected to a Linksys BEFSR 41 Router. ...
    (microsoft.public.windowsxp.network_web)