Re: Whats Wrong With This Router

perform the password recovery procedure and
set the config register ( o/r 0x2142 ) to skip loading config at
bootup

see
http://www.cisco.com/en/US/products/hw/routers/ps233/products_password_recovery09186a0080094795.shtml

if router comes up, capture the output of show version and dir flash:

if router comes up, then use " configure memory"command to copy the
NVRAM into memory

shutdown the token-ring interface to avoid lobe messages on bootup

.

Relevant Pages

  • Re: Internet connection delay.
    ... Aresuming from standby, my pc, wired to the router, takes 20-30 seconds ... to connect to the internet. ... I have the same problem only from bootup. ... Three computers from a Linksys ...
    (microsoft.public.windowsxp.general)
  • RE: cisco 2513 router
    ... boot the router and interrupt its boot process with a Ctrl + Break key ... Subject: cisco 2513 router ... I just received a cisco 2513 router w/16 Meg of Flash that I purchased on ... reference to resetting the config register to 0x142, ...
    (Security-Basics)
  • Re: 1602 not reading startup-config....
    ... Disregard -- found out what it was, thanks to AN for the heads up. ... when the password recovery was run on the router, the config register was ...
    (comp.dcom.sys.cisco)
  • Re: 7026VXR reload
    ... did you manually reloaded the router or did it reloade due to the ... what is the value of the config register - post output of show ...
    (comp.dcom.sys.cisco)
  • Re: 1751-V **Software emulation error*
    ... The router was sitting in my office for several ... What would be the config register that will ignore the config? ... The rommon command to cause that should be ...
    (comp.dcom.sys.cisco)