Re: routing problems with multiple T1s - I know whats wrong but dont know how to fix it

a few comments about the config:

1. Why has CEF been disabled ( no ip cef) ???

2. The following two static routes are duplicate, remove the one
pointing to interface
ip route 172.25.7.0 255.255.255.0 Serial0/0/0:0
ip route 172.25.7.0 255.255.255.0 10.2.10.2

.

Relevant Pages

  • Re: Load Balancing Multiple Cisco Routers with Multiple ADSL circuits
    ... Equal-cost load-sharing with CEF works without any problem with static routes as long as you do not play with the administrative distance. ...
    (comp.dcom.sys.cisco)
  • Re: Subnet & VLAN question
    ... I don't know much about the Omniswitch, ... > I don't think they support EIGRP unless I am wrong. ... >> static routeS or a routing protocol. ... >> if you need a config for it. ...
    (microsoft.public.windows.server.networking)
  • Re: Subnet & VLAN question
    ... > I don't think they support EIGRP unless I am wrong. ... >> static routeS or a routing protocol. ... >> if you need a config for it. ... Prev by Date: ...
    (microsoft.public.windows.server.networking)
  • Re: CPU utilization on the router.
    ... sh ip cef ... and post your config ... Prev by Date: ...
    (comp.dcom.sys.cisco)
  • Re: High CPU utilization on Cisco 1760
    ... Post the config along with the following output: ... show ip cef ... show interface stats ... Prev by Date: ...
    (comp.dcom.sys.cisco)