Re: getting in
- From: fatlobsterman@xxxxxxxxx
- Date: 8 Feb 2006 06:52:45 -0800
[PIX 515E]
In most PCs that I have seen, COM3 is either not connected at all,
or is a modem port; the standard serial ports that are connected
are COM1 and COM2. On most laptops that I have seen, the standard
Hi Walter
I have one serial port on my PC so I used the pc connector then the
rj45 cable out of there and into the console. I tried doing com1 setup,
com 2 setup and com3. Which number com should I use?
The quick start guide says the hardware features 433 celeron processor,
64 mb for UR and FO pix systems which I have one of each. Is is safe to
assume that I have at least that and all the other info that is listed
like 16mb flash, etc.? I think also when I was trying to load software
it said 6.3 which like the other stuff, is this probably what the
system has?
These are brand new so hopefully it won't be a big deal to get in now
that I may be somwhat setup. Is it a project to do the rest?
I really appreciate your assistance.
George
.
- References:
- getting in
- From: fatlobsterman
- Re: getting in
- From: Walter Roberson
- Re: getting in
- From: fatlobsterman
- Re: getting in
- From: fatlobsterman
- Re: getting in
- From: Walter Roberson
- getting in
- Prev by Date: Advice on adding fiber GBIC's to 3500 and 2950
- Next by Date: Re: How to force DHCP client router to renew its lease?
- Previous by thread: Re: getting in
- Next by thread: memory
- Index(es):
Relevant Pages
|
