Re: Cisco 1750 Config...

Well /29 is .248 so you're correct there. Did the telco you are
leasing the T1 from confirm that it's up? Any alarms on the demarc
when you're plugged into the router?

The config looks okay to me, but then I have very little experience
configuring a router to get onto a T1 other than copy and paste configs
someone else put together.

Dave
Still a newbie CCNA.

.

Relevant Pages

  • Re: Probleme with nm-16am v1.0
    ... the router worked perfectly until electrical outage then the tow cards ... sh start - displays the time the config was last saved *however* ... modem country microcom_hdms europe ... interface FastEthernet0/0 ...
    (comp.dcom.sys.cisco)
  • IPCOP|SMOOTHWALL+IPSEC+WINDOWS+ROUTER x VPN (lungo)
    ... I have problems with a VPN configurations I'm not able to set good; ... think that a physical router is interfereting with the VPN, ... IPCOP machine is visible directly from internet: I have config DLINK ... conn roarwarriors ...
    (comp.security.firewalls)
  • RE: deny access
    ... If this is an edge router you'd like secure it a bit more, ... Subject: deny access ... ACL to block one host would effectively block all hosts. ... From interface config mode, ...
    (Security-Basics)
  • Re: how to inquire about Linksys WAP54G wired to desktop?
    ... So it appears that changing from 15 on my router ... a setup screen for my AP I like your suggestion but I have no clue ... I didn't know my PC had an IP config ... I'm doing is done thru a wired connection -- I haven't yet used anything ...
    (alt.internet.wireless)
  • Re: home lan setup suggestions
    ... Router internet config dialog shows: ... Default gateway: xxx.xxx.xxx.N+1, being the IP assigned by ISP ... Modem manages the connection/disconnection to internet, ... The router itself uses the gateway IP given to it by the ISP. ...
    (comp.security.firewalls)