Cisco VPN Client Issues

I get the following error message when trying to connect to a remote
site:

"The client did not match the firewall policy configured on the central
site VPN device. Cisco Systems Integrated Client should be enabled or
installed on your computer."

When I check Stateful Firewall (Always On), it does the same thing and
the log file fills up with:

Sev=Warning/2 IKE/0xE300008A
Stateful Firewall (Always On) failed to start.

In addition, I have the following error in my Event Log:

Event Type: Error
Event Source: TrueVector Service
Event Category: None
Event ID: 5003
Date: 11/28/2005
Time: 1:16:49 PM
User: N/A
Computer: DAVESLAPTOP
Description:
TrueVector driver: Driver install or load failure: LoadNTDeviceDriver.
Win32 error: The service cannot be started, either because it is
disabled or because it has no enabled devices associated with it.


Now, I've done a lot of searching around on the Internet and the Cisco
site, but can't seem to find any solutions. I've tried the newest
version of the Cisco VPN Client and gone back to the older version we
still use at the office, same thing.

This is a clean install of Windows XP Home on my laptop so there has
never been any instance of ZoneAlarm installed on it. I have done
several uninstall/reinstalls of the VPN Client, tried with the Windows
Firewall turned on, tried with it turned off, tried with the Sygate
Personal Firewall I use normally turned on, turned off, etc.

Anyone have any ideas?

Dave

.

Relevant Pages

  • Re: Trend SMB 3.0 Issues
    ... Officescan communication between client/server uses some ports, ... On one client machine - if you have the client installed, ... > click in a group - click add - and successfully install remotely. ... > sounds like XP firewall. ...
    (microsoft.public.windows.server.sbs)
  • Re: Firewall Hardware and a bit of a Rant
    ... I need advice on which hardware firewall to purchase for a client with 20 users. ... I'm fairly new to SBS and have installed 3 servers. ... Watchguard seem to think they are Cisco and don't have to provide support to smaller IT guys because they are so powerful etc.. ... If my client didn't need web filtering, I'd bang a PIX in and use the Cisco VPN Client for remote access with local database XAuth to provide double authentication. ...
    (microsoft.public.windows.server.sbs)
  • Re: Trend SMB 3.0 Issues
    ... On a client machine I tried this article (per Trend suggestion) ... error popped up "Apnt.ini not found", and the install terminates. ... > On one client machine - if you have the client installed, ... >> sounds like XP firewall. ...
    (microsoft.public.windows.server.sbs)
  • Re: AS4.1 and XV6700
    ... It is only when reading that you had problems with your Cisco VPN ... When you open the Cisco VPN client and click the Options tap, ... the BlackIce firewall is also installed. ... that partially worked was when I booted the PC into safe mode with network ...
    (microsoft.public.pocketpc.activesync)
  • Presentation: Bypassing client application protection techniques with notepad
    ... Bypassing client application protection techniques ... Kerio Personal Firewall 4.0 ... Last years were revolutionary for network services infrastructure ...
    (NT-Bugtraq)