Re: VLnas and cisco 871.

Hello Alex,

the 871 supports VLANs with the Advanced IP Services feature pack...
As for the switch that does not support trunking: whatever you connect
to one of the 10/100 ports on the switch, will belong to the VLAN
configured for that port. To give you an example:

interface FastEthernet1
switchport access vlan 101
!
interface vlan 101
ip address 192.168.1.1 255.255.55.0

So, if you have a switch connected to FastEthernet 1 on the 871, and if
the switch does not support trunking, all ports on the switch must be
configured for VLAN 101...
Is that what you are asking ?

Regards,

GP

.

Relevant Pages

  • Re: Configuring Cisco IPS High Bandwidth Using EtherChannel Load Balancing
    ... "If the paired interfaces are connected to the same switch, ... VLANs for the two ports. ... IPS is able to track traffic per-VLAN, ... VLAN Pair mode uses one interface only and this is the only supported ...
    (Focus-IDS)
  • RE: ID sensors on a Cisco Catalyst 6509 switch
    ... ID sensors on a Cisco Catalyst 6509 switch ... capability using the VLAN ACLs. ... We'll use ports 1-4 on the 10/100 mod. ...
    (Focus-IDS)
  • Re: Creating VLANS on 6500 IOS 12.2
    ... How do you just create a basic VLAN for a few ports so the devices in ... so they want me to give them two ports of the ... On a Cisco layer-3 capable switch running IOS there are two ways to ... configure a layer 3 interface. ...
    (comp.dcom.sys.cisco)
  • RE: ID sensors on a Cisco Catalyst 6509 switch
    ... ID sensors on a Cisco Catalyst 6509 switch ... capability using the VLAN ACLs. ... We'll use ports 1-4 on the 10/100 mod. ... selection of capture ports. ...
    (Focus-IDS)
  • Re: 470-48T switches can I do this?
    ... My fibers are going into the core, one is on the 172.16.x.x vlan while ... those that are used on the core switch. ... set the ports or MLT on ES470 and core switch as trunk port. ...
    (comp.dcom.sys.nortel)