Re: Internet access for remote site over dedicated T1 line w/ Cisco 1720s
- From: "cisco" <nitishh@xxxxxxxxx>
- Date: 28 Sep 2005 18:00:32 -0700
first are you using any dynamic routing protocol like rip,ospf anything
?
If not and you dont intend to then try this
on site a 2501 configure a static route
ip route 10.10.50.0 255.255.255.0 10.10.40.254
next configure on site B
ip route 0.0.0.0 0.0.0.0 192.168.1.254
on the b site use 10.10.50.254 as your default gateway.
what i think is happening is that may be the 2501 router does not know
how to get to site b . in other words 2501 does not have a route to
site b. you can confirm this by looking at your routing table command
is
show ip route
so i put a static route on 2501 to send all the traffic to site b to
the 1720 at site A
next on B site i put a default route to site a and asked the router on
site B to send all traffic to site A . once the traffic comes to site A
it should be ok.
There still remains lot of questions un answered . do you have nat
configured but we can get to that after you try this please if possible
try to do this after office hours and also post your running configs .
thanks
should work i think
.
- Follow-Ups:
- References:
- Prev by Date: Re: Pix 501 VPN to Ravlin 3300
- Next by Date: Re: modifying route metric with ospf
- Previous by thread: Internet access for remote site over dedicated T1 line w/ Cisco 1720s
- Next by thread: Re: Internet access for remote site over dedicated T1 line w/ Cisco 1720s
- Index(es):
Relevant Pages
|
