Changing router access and VPN policy key passwords

Hi,

On an existing, configured 1721 router (v.12.3) I need to change

1)the password to access the router (SSH and HTTP)

I think this is the step-by-step procedure, after logging into the
router with SSH:

#config t
#line vty 0 4
#password <new password>
#exit
#enable secret <new password>
#end
#writ mem

Is that correct?

2)the key password (Existing_Password_Here) at the VPN policy section:
!
crypto isakmp client configuration group access
key Existing_Password_Here
dns 192.168.180.14
vns 192.168.180.14
domain mydomain.com
pool ippool
acl100
!

(This - key password - will be the Group Authentication password in the
Cisco VPN client software configuration.)

I would highly appreciate any help.

Thanks!

R. Nick

.

Relevant Pages

  • Re: SBS 2003 Misconfigured?
    ... Netgear router because it has 8 ports, utilizes UPNP (at least it did it ONCE ... You mentioned that you assigned the ISP IP to netopia AND the netgear. ... You *can* configure the netopia to operate in bridged mode, but in this configuration, it is literally acting as modem, converting DSL/ATM traffic to ethernet and would not hold a public IP of its own. ... Quickbooks on my server (I know, I shouldn't but I HAVE to because another ...
    (microsoft.public.windows.server.sbs)
  • Re: SBS 2003 Misconfigured?
    ... I agree, with what I could have / should have done as far as the router, ... Why didn't you just disconnect the Netgear and not touch the Netopia? ... Which, based on the configuration you gave, is part of the ...
    (microsoft.public.windows.server.sbs)
  • Re: OT:--CISCO EXPERTS...
    ... boxes and Cisco routers connected to these with X21 cable. ... You mention steep learning curve but if I can just get ino router maybe can ... > want to consider any risk of providing them with an insecure configuration ... >>> Telnet access should also be disabled leaving connection via SSH or ...
    (microsoft.public.windows.server.sbs)
  • Re: Port forwarding and ssh
    ... > I have a simple adsl router and gateway on the configuration i can allow ... Is there a special configuration for ssh ...
    (Fedora)
  • Home DSL configuration BNCP problems
    ... The router information is as follows: ... With the posted configuration the dsl link is actually up and also the ... Outbound bridge packet dropped, BNCP state is Listen ... Vi2 BNCP: TIMEout: State Listen ...
    (comp.dcom.sys.cisco)