route field

Relevant Pages

• Re: route field
  ... is there is a necessity of route field in layer 2 switch ... ... to support. ...
  (comp.dcom.lans.ethernet)
• RE: Use of Taps for IDS
  ... this is a layer 1 (physical ... Note that this usually requires all the ports to be of a single ... of each connected machine whenever a frame is sent. ... the switch typically floods ALL ports with the ...
  (Focus-IDS)
• Re: VPN Design - is it possible?
  ... >> you can have the two ISPs converge at a device outside the PIX A, ... the PIX to a switch and connect the switch to the two routers, ... appropriate "only one switch active at a time" failover logic. ... convertor is still up) Can the device discover the layer 1 failure by ...
  (comp.dcom.sys.cisco)
• Re: [fw-wiz] Layer 2 (stealth) firewalls - PBR?
  ... Layer 2 devices like switches have to forwrd layer 3 multicast packets out ... Protocol (IGMP) and Multicast Listener Discovery Snooping Switches. ... In the case of IP multicast traffic, an IGMP snooping switch provides ...
  (Firewall-Wizards)
• Re: The cat came and stayed..
  ... To me this implicates a layer three problem. ... So, to cut a long story short, ISP had provided us with EoATM 100 mbps link ... There are two cisco routers across Sites A and B and two media changers at ... I reset any switch, the problem gets resolved. ...
  (Pen-Test)