Re: Is solid edge comparable, better or worse than SW?
- From: phil scott <phil@xxxxxxxxxxxxx>
- Date: Wed, 2 Jul 2008 08:07:24 -0700 (PDT)
On Jul 2, 2:52 am, Cliff <Clhupr...@xxxxxxx> wrote:
On Wed, 2 Jul 2008 00:19:33 -0500, "ken" <goa...@xxxxxxxxx> wrote:
If you ask this question on a SolidWorks news group, what answer do you
expect to get? One poster who claimed to use both products, reported having
to do extra work in Solid Edge. Aside from the fact he didn't know what he
was talking about, that's the typical answer your going to get here. Check
it out for yourself. You do not need to project geometry to constrain to it
in SE, that was just pure rubbish.
CCS does often have mention of SE and the actual official SE
group is a private one internal to ugs.com athttp://bbsnotes.ugs.com/
(I notice that they now have a free student section - otherwise you
need an account for your legal copy of SE, UG, etc.)
But the SE student section only has about 8 messages.
My v20 version of SE was shipped last friday, I will pick it up this
weekend, by blowing off one of my autocad programs (leaving IV in
place so i can access its killer libraries)... and give it a test
ride. The seimens vendor rep said my laptop would be way slow with
SE synch and recommended a dell 2,000 dollar laptop... in checking it
out, it was not impressively fast, dual core is all, a nyvidia
graphics card...and came with only 1 gig of ram.
My compac is single core, 2 mhz and 2 gig of ram.. cheezy ATI
graphics card (AMD cpu)it runs inventor just fine.. id bet it runs SE
well too.. maybe i will have to upgrade when synch comes out. i can
access the SE in house group maybe... if I have time this weekend i
will get it loaded etc and ask them whats up and post it here... still
if that mouse mik dell will run synch.. my current laptop should.
Phil scott
--
Cliff
.
- Follow-Ups:
- References:
- Prev by Date: Re: Drawing views are on an angle, how to change?
- Next by Date: Re: Is solid edge comparable, better or worse than SW?
- Previous by thread: Re: Is solid edge comparable, better or worse than SW?
- Next by thread: Re: Is solid edge comparable, better or worse than SW?
- Index(es):
Relevant Pages
|
