Re: Simple way of making Golf Ball with Solidworks!

On Tue, 7 Mar 2006 14:49:13 +0200, "Heikki Leivo"
<heikkidotleivo@xxxxxxxxxxxxxxxxxxxxxxxx> wrote:

No need for projection, which would introduce trig errors.
Just get them the same "diameter" to begin with such that either
the vertexes or the face centerpoints lie on the sphere.
Then do the same with other icosehedrons rotated in 3D
about the center of the sphere.

It would be interesting to see your version of the golf ball, Cliff (if you
modeled it...). At least in my version only a tiny piece of one icosahedron
was needed, and still the result (eg. dimple distribution) was pretty good.
Of course you can use multiple, whole icosahedrons but it sounds quite
tedious to me.

I pointed out a way to decide the number of possible regular dimple
locations based on Platonic solids and checked a few suggested
examples.
Given that as a hint .... <G>.
Do they fudge gold balls?
--
Cliff
.

Relevant Pages

  • Re: Earths Surface As Soccer Ball
    ... icosahedron, subdivide the triangular faces, and project their new ... vertices outward to the surface of the sphere. ... original icosahedron will have an approx 72 degree angle while those ...
    (sci.math)
  • Re: Simple way of making Golf Ball with Solidworks!
    ... the vertexes or the face centerpoints lie on the sphere. ... At least in my version only a tiny piece of one icosahedron ...
    (comp.cad.solidworks)
  • Re: Dodecahedron Inside a Sphere?
    ... So I should be able to cut 30 pie-wedges with this angle and make a sphere ... let L/R be the ratio of a polyhedron edge to the radius of the ... For a dodecahedron in a sphere I get: ... For an icosahedron in a sphere I get: ...
    (sci.math)