Re: Need Basic Help

You can also choose the end of the shaft as a sketch plane and sketch a
circle of the INSIDE diameter of the groove. Then you do a Cut-Extrude
choosing the Offset option (in the "From" scroll box) and setting the
offset to be the distance from the end that you want the groove to
start. Set the width of the groove as the value under "Blind" and
select "Flip side to cut".

'Sporky'

John Kreutzberger wrote:
>
> > How would you add a snap ring groove onto a round shaft.?
> > Thanks
> >
> >
> cut-revolve
.

Relevant Pages

  • Re: Why does my woodruff key keep breaking?
    ... The shaft is not tapered, ... The groove on the shaft is 5.5mm while the ... Regarding material used and manufacturing technique. ... grinding down. ...
    (uk.rec.motorcycles.classic)
  • Re: Gear shift pedal replacement
    ... It fits in a groove on the shaft ... so even when loose it won't fall off, just strip the splines so it's ...
    (rec.motorcycles.harley)
  • Re: Why does my woodruff key keep breaking?
    ... The shaft is not tapered, ... The groove on the shaft is 5.5mm while the ... angle iron which was the closest to 5.5mm and thus needed the least ... grinding down. ...
    (uk.rec.motorcycles.classic)
  • Re: Ideas on a motor coupling?
    ... Take advantage of the 3 threaded holes on the housing and make a plate ... Put a groove into the OD of your shaft, make a plate that hits the 3 bolt ...
    (rec.crafts.metalworking)
  • Re: Ideas on a motor coupling?
    ... Take advantage of the 3 threaded holes on the housing and make a plate retainer. ... Put a groove into the OD of your shaft, make a plate that hits the 3 bolt holes and has a loose-fit U that will fit inot the groove on the shaft. ...
    (rec.crafts.metalworking)