Re: How to mate a cylinder and a cube

BTW, I have tried reference geometry, but it does not seem to be
selectable in the assembly, only in the part... is there a way to
change this?

davidd31415 wrote:
> My appologies if the first post got through to anyone...
>
> I'm trying to mate the center of a cylinder (flat side) to the center
> of a side of a cube... any recommendations on how to line this up?
>
> Thanks,
>
> David.

.

Relevant Pages

  • Re: Web Administration Service(WAS)
    ... Top answer David! ... > BTW, the information is all sitting in front of you in the OS. ... Prev by Date: ...
    (microsoft.public.inetserver.misc)
  • Re: RTE dinner in Paris 22 October?
    ... > BTW, where is Chez Denise, precisely? ... David Horne- http://www.davidhorne.net ... Prev by Date: ...
    (rec.travel.europe)
  • Re: La Marzocco in Florida
    ... BTW, your post in the older thread in CG has made that thread immediately ... - David R. ... Prev by Date: ...
    (alt.coffee)
  • Re: Leaving neg. feedback on ebay
    ... >Thanks once again, David. ... BTW, I've emailed you a few times to thank you ... Not sure if the emails have gotten through though. ... Prev by Date: ...
    (alt.fashion)
  • Re: Duplicate key error
    ... "David Browne" wrote in ... Now to get your inferior workaround to actually work, ... > must wrap the select maxand INSERT in a serializable transaction. ... > BTW, you can perhaps use an IDENTITY column on a different table to ...
    (microsoft.public.sqlserver.programming)
Loading