Re: Question?

Mama Bear,

I'm no expert but what I do is change the ucs using the 3 point ucs
icon in the drop down menu. This will allow you to show the dimension
in the same plane as the ucs. You can do this as many times as you
need.


JPC

On Fri, 02 Feb 2007 15:02:14 -0600, Mama Bear <MamaBear@xxxxxxxxxxx>
wrote:

Mama Bear <MamaBear@xxxxxxxxxxx> wrote :

It's been a few years since I took the AutoCAD program at Emily
Griffith, I didn't even get through the whole thing and haven't
worked in the field, so I'm afraid I've forgotten what little I
learned about 3D.

But I'm trying to draw a 3D rendition of a box, anyway, for someone
to weld for me.

Are there any of you who wouldn't mind answering a question for me?

Ok, here:

http://lakewoodcolorado.net/MamaBear/Box1.jpg

I basically sketched out the box, not knowing what the heck I'm doing in
3D anymore, and then tried to dimension it, but the dimensions are
upside down and screwy in some cases, as you can see on the left side
there. Different planes or views or something? :)

.