Re: ML506 Platform Flash

On Apr 14, 1:23 pm, "Pedro" <pete.dud...@xxxxxxxxxxx> wrote:
Hello

Has anyone figured out how to program and configure from the Platform Flash on the ML506. I have spent a lot of quality time with the ML505/ML506 Getting Started Tutorial (ug348.pdf) without luck.

There is a dip switch (SW3), the Impact settings and a pair of XCF32P flashes.

I just want to configure from one of the flashes on power up.

If anyone can tell me the exact settings that make the flashes usable I would be very grateful.

Pete

I am using ML505 and I configure the fpga from PROM in Parallel mode.
SW3 Setting is following

1 Off
2 Off
3 Off
4 On
5 Off
6 Off
7 Off
8 Off

ML505 Evaluation Platform User Guide (ug347) Explains the DIP settings
required for different modes of configuration.

-Sovan.

.

Relevant Pages

  • Re: Error warning when shutting down pc
    ... AumHa VSOP & Admin http://aumha.net ... This flashes on the screen too fast for me to read/write down all the ... I was advised to review the event logs, ... settings for startup & recovery to longer than the 30 seconds it shows... ...
    (microsoft.public.windowsxp.general)
  • XP Pro wont open
    ... Message says "Registry cannot load the hive" and then flashes ... "physical memory dump complete" and asks me to choose safe mode or "last ... good settings" or "normal" but none works. ...
    (microsoft.public.windowsxp.general)
  • Re: access 2007 will not print report
    ... I've removed the api call and the modal and pop up settings so that it ... This didn't resolve the problem. ... flashes up with a print dialog like it's spooling to the printer and ...
    (comp.databases.ms-access)
  • Re: HP 4155 ActiveSync "Attention Required"
    ... One more discovery. ... It flashes up a ... message box saying "Opening Settings", ... but not the outlook items.) ...
    (microsoft.public.pocketpc.activesync)
Loading