Re: System crashes when configuring altera stratix pci board
- From: "Nial Stewart" <nial@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Tue, 28 Feb 2006 11:59:23 -0000
I have been trying to get Altera's Stratix PCI Development Kit to work.
The device on the board is EP1s25f1020c5.
My design has a 32 bit PCI target core, alongwith a simple backend
design that
- sends a ready signal back to the PCI core following a framen signal
from the core
- and then reads in data (in case of a target write)
When I try to use the sof file to configure the device, the whole
system hangs. The configuration LED shows that the device is
configured.
Is there no config device on board you can program so the board will
be configured on power up before the PCI bus configuration is
performed?
(Have you simulated your design ?)
Nial.
.
- References:
- Prev by Date: Re: PCI configuration for ML310
- Next by Date: Re: New XC9572 decoupling newbie question :-)
- Previous by thread: Moreover, the fpga hangs even when I configure a very simple design too...
- Next by thread: Observed a bug in the Model sim V 6.0a
- Index(es):
Relevant Pages
|
