Re: PCI configuration for ML310

Hi,
I made a hardware module which gets as input all the PCI interrupt
lines and merges them into a single one. The merge is done in the same
way the misc_logic module of the Xilinx base configuration, it means
all inputs are inverted except the SBR one.

When using this hardware configuration the kernel is unable to boot. I
think due to the interrupt line is always asserted. Does anybody know
the correct way of merging the interrupt signals?

Regards,
Isaac

.

Relevant Pages

  • Re: Firewire interface -> dropouts, IRQ?
    ... PCI slots is assigned to a single PCI interrupt channel ... with the SATA controller, both PCI-E slots (I assume you have your ... If IRQ contention is in fact your problem, ...
    (rec.audio.tech)
  • Re: DUAL Lan Adapter:No Network Connection
    ... You may want to check the interrupt line, if the DLL is loaded and the ... NDIS is trying to bind the adapter with an IP address, ... This could be a PCI interrupt routing problem on the ... > IPNotifyClientsIPEvent: PendingIPGetIPEventRequest 5a0a0 ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Why PCI9054 fails to assert pci interrupt when local interrupt input is pulled down? Any advice
    ... I meet a problem of interrupt. ... I wanna assert a PCI interrupt using ... when I set INTCSR as 0X0f000800 (PCI interrupt is not ... I dont know its the reason of WinDriver diagnostic program ...
    (comp.arch.fpga)
  • Re: PCI Interrupts
    ... Maxim Shatskih, Windows DDK MVP ... interrupt, making all the PCI interrupt handling transparent. ... model, where you send an IOCTL to the driver, and it is pended until the ... The application has to know when this PCI interrupt occurs. ...
    (microsoft.public.development.device.drivers)