PPC405 on ISE

Hi everyone,

Is there any way for me to start a project on Virtex2Pro utilizing the
PPC405 core using ONLY ISE (i.e. without EDK)? How do we instantiate
the core in VHDL?

I'm not really keen on using the EDK: (1) Too many 'black-box-wizards'
- I'd like to know what connections are made and how it is connected.
(2) Sometimes when I made some changes to my custom peripheral, the
whole system becomes not usable - you know, the frustration of waiting
for it to rebuild the system only to find it doesn't work AT ALL!

Ooh.. by the way, I'm using the ML310 development board (XC2VP30).

Thanks.

-Azman-

.

Relevant Pages

  • Re: Spartan3E Starter Kit MISO and Flash pin shared
    ... using a core in EDK. ... Minimally, define a module with OUT pins for the two now disconnected nets, additional pins for selection, and an IN pin for the external net. ... My normal workflow wraps the EDK project in an ISE project. ... Instantiate the switcher/mux in the top most module, at the same level you instantiate the EDK system. ...
    (comp.arch.fpga)
  • Re: PPC405 on ISE
    ... You might want to look at UltraController-II for an example that uses ISE for a PPC based design. ... even in this example EDK is used to compile software source code. ... PPC405 core using ONLY ISE? ... - I'd like to know what connections are made and how it is connected. ...
    (comp.arch.fpga)
  • Re: PPC405 on ISE
    ... PPC405 core using ONLY ISE? ... - I'd like to know what connections are made and how it is connected. ... It is helpful to start with a working EDK created project that is somewhat similar to what you eventually want, and then modify it by hand from that point on. ... you can execute "make" with the appropriate options to build the project. ...
    (comp.arch.fpga)
  • EDK 9.2 Woes
    ... I updated to EDK 9.2 primarily b/c we are building a new project and I ... back to what it was when the core was pulled in. ... The MPMC3 configuration GUI displayed the correct address width ... custom IP is setup with the correct NPI information (Answer Record ...
    (comp.arch.fpga)
  • Re: Slightly OT. Heat and a Bench Light ...
    ... plastic surround had almost compleatly gone and the connections were ... One general thing to be aware of these Anglepoise lamps. ... electronic hints and repair briefs, ... other than a 2 core plastic cable on it. ...
    (sci.electronics.repair)