Re: boot from flah

From: Athena <lnzhao@xxxxxxxxxxxxxxxxxx>
Date: Tue, 29 Nov 2005 19:09:02 -0800

Hi all,

At present I am using EDK7.1 to do projects. By EDK I get a file "download.bit". If i use the "impact" of ISE7.1, i can download this file to the Virtex-ii Pro50 fpga board(produced by memec insight), but the file is in ram, so I have to download it every time when the power is on. However, I want to download the file in prom or flash once, and make the the system run every time when the power is on. According to EDK document "Chapter12 Programming flash memory", I think it is possible. However i couldn't find the prom on the fpga board when using the impact to check the device. Or maybe I can use flash or system ACE, but my flash is the one I said at the beginning, It is not OK according to the edk document. I will do some tests with system ACE.

Cheers. Thank you!

Athena
.

References:
- boot from flah
  - From: Athena

Prev by Date: Re: async fifo design
Next by Date: Re: Q-bus or Unibus bus transactions in FPGA?
Previous by thread: Re: boot from flah
Next by thread: Altera Pin not used in Quartus project but drives logic
Index(es):
- Date
- Thread