Virtex4 : Downloading error
- From: Shakith <cybershakith@xxxxxxxxxxx>
- Date: Tue, 30 Aug 2005 21:25:17 -0700
I created microblaze design using bases system builder for virtex 4 lx25 lc board using Xilinx EDK 7.1i sp2.
After downloading, when using xmd to connect, the following error happens..
JTAG chain configuration -------------------------------------------------- Device ID Code IR Length Part Name 1 0167c093 10 XC4VLX25 Assuming, Device No: 1 contains the MicroBlaze system WARNING:EDK - MDM Peripheral Not Detected on Hardware WARNING:EDK - Assuming opb_jtag_uart peripheral Connected to the JTAG MicroProcessor Debug Module (MDM) No of processors = 1
UNKNOWN Processor Version (0) Verify if FPGA Bitstream was downloaded and DONE pin went High
FPGA bitstream was properly built and downloaded to the system.
likely possible causes : 1. JTAG cable 2. EDK downloading issue like the ise 7.1i doent program single virtex4 devices after sp3
Any advice.
Thanks
Best Regards Shakith
.
- Follow-Ups:
- Re: Virtex4 : Downloading error
- From: Jason Wu
- Re: Virtex4 : Downloading error
- Prev by Date: Version 5.0 of Quartus University Interface Program (for researchers & graduate students) Released
- Next by Date: Re: Simulation problems with EDK 7.1.02i and ModelSim SE 6.1a
- Previous by thread: Version 5.0 of Quartus University Interface Program (for researchers & graduate students) Released
- Next by thread: Re: Virtex4 : Downloading error
- Index(es):
Relevant Pages
|
|