Re: Fuzzy controller in Simulink for an AC servo motor

I may have got something. I don't know if this will work. Here is what
i did:
1. I got my FIS file onto the workspace and loaded it into the FLC
Block on Simulink.
2. I looked under the mask of the FLC block to open the FLC. It showed
me a 1 I/O block.
3. I again looked under its mask to open the FIS wizard. This showed my
rule base.
4. It had 1 input which was then connected to my 2 inputs via a demux.
I deleted the demux and added one more input source and connected them
individually to the 2 inputs that i have.
5. I also added one more input source to the FLC block.
6. Now when I see my main window in simulink, the FLC block shows me 2
inputs and 1 output.

I think this should work. Let me know if I'm doing this completely
wrong.

Slinux

.